Viewing meshes:
	Hold mouse left button and move for camera-view control
	Hold mouse right button and move for translate
	Mouse wheels are used to zoom in/out
	Press W to show/hide mesh edges
	Press R to reset camera


Toolbar from left to right:
	Open files (find a few examples in folder ./data)
	delete selected folds
	turn on/off selecting fold parameter mode
	turn on/off applying fold parameter mode
	run physical simulation
	refine mesh resolution


Drawing folds:
a)	Press and hold Shift button to enter Drawing-fold-hints status
       	Release shift to leave this status
       	Mouse cursor is changed to a stroke when in Drawing-fold-hints status
       	Following operations (except for (d)) are only allowed in Drawing-fold-hints status
b)	Hold mouse left button and move to draw a fold hint
	Release left button to complete a drawing
	(*)Double- click left mouse button leads to entering/leaving a polyline drawing status.
	In this status, move mouse (do not hold the left button) and single-click left mouse button to add vertex.
  	(*) bugs exist when the whole sketch curve is outside the sheet
	or when the outside part of the sketch forms a loop (PLEASE DO NOT MAKE THIS SKETCH)
c)	Hold mouse right button to drag a rectangle for selecting drawn fold hints
        (*) In selecting fold parameter mode, fold magnitude and sharpness will be selected from the selecting fold
	(*) In applying fold parameter mode, fold magnitude and sharpness will be applied to the selecting fold
d)	Slider bar shows the magnitude and sharpness controller for the selected fold hints
e)	Other controls:
	a.	Keyboard  Left/right/up/down button can be used to adjust stroke color and width
	b.	Keyboard F switch line/free-form curve drawing
	c.	Keyboard M switch single/multiple selecting mode
	d.	Select no fold hint to deselect all fold hints

copyright (C) 2013 Lifeng Zhu,
contact: lfzhulf@gmail.com



